Ink Ribbon Installation - Mitsubishi Electric CP-W5000DW Operation Manual

BEFORE OPERATION
Before installing the ink ribbon cassette into this printer, load the ink ribbon in the ink ribbon cassette.
• Place the ink ribbon cassette on a flat surface, when loading the ink ribbon.
• Select a place that is free of dust when loading the ink ribbon. Dust or dirt settling on the ink ribbon results in poor
print quality.
• Make sure that the shafts of the ink ribbon fit into the ink ribbon cassette firmly.
Load the ink ribbon in the ink ribbon cassette as shown below.
Make sure to load it in the correct position.
Make sure to set the ink ribbon roller to the ink ribbon cassette firmly.
Turn the shaft to eliminate any slack.
Press the POWER switch on the rear panel to turn on the
power.
After the POWER indicator changes from orange to
green, press the front release button and pull out the
slide door by the handle at the front bottom. Pull out the
slide door until it stops.
• Do not push down on the slide door. If you push down on the
slide door when they are open, this printer may fall and it can
cause damage or injury.

INK RIBBON INSTALLATION

Ink ribbon
2
1
Ink ribbon cassette
NOTE
CAUTION
NOTE
White parts
POWER
switch
Shaft
Front release
button
Handle
10