Table of Contents
Advertisement
1. SAFETY INSTRUCTIONS
Overview
•
General Safety Instructions
•
Projector Related Safety Instructions
This manual is intended for the user/operator of the installed projector. Any change in cabling or servic-
ing of the installed projector must be performed by service personnel having appropriate technical
training and experience necessary to be knowledgeable of potential hazards to which they are exposed in
performing a task, and of measures to minimize the potential risk to themselves or other persons.
1.1 General Safety Instructions
Lightning
For added protection for this projector during a lightning storm, or when it is left unattended and unused for long periods of time, unplug
it from the wall outlet and disconnect the power cord. This will prevent damage to the projector due to lightning and power-line surges.
Object and Liquid Entry
Never push objects of any kind into the modules through openings as they may touch dangerous voltage points or short-out parts that
could result in a fire or electrical shock. Never spill liquid of any kind on the product.
Servicing
Do not attempt to service the modules yourself as opening or removing covers may expose you to dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
Damage Requiring Servicing
Unplug the modules from the wall outlet and refer servicing to qualified service personnel under the following circumstances:
•
If the power-supply cord or plug is damaged.
•
If liquid has been spilled, or objects have fallen into the projector.
•
If the projector has been exposed to rain or water.
•
If the product exhibits a distinct change in performance, this indicates a need for service.
1.2 Projector Related Safety Information
On Cooling
The cooling fans in this projector continue to run for about 1 min. after the projector is turned off. During normal operation, when turn-
ing the power off always use the power down function on the remote control. Ensure the cooling fans have stopped before switching off
the projector using the power switch.
DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE POWER CORD. FAILURE TO
OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILURE.
Slots and Openings
Slots and openings in the cabinet and the sides are provided for ventilation; to ensure reliable operation of the projector and to protect
it from overheating, these openings must not be blocked or covered.
Protection from Ultraviolet Radiation
WARNING: DO NOT LOOK DIRECTLY IN THE HIGH INTENSITY LIGHT BEAM. The lamp contained in this product is an intense
source of light and heat. One component of the light emitted from the lamp is ultraviolet light.
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
R5976691 CINE VERSUM 70/60 24112003
SAFETY INSTRUCTIONS
3
Advertisement
Table of Contents
