Sharpness (Detail) Control; Color (Saturation) Control - Barco Cine VERSUM 60 Owner's Manual

6. IMAGE CONTROL
Image 6-3

6.3 Sharpness (Detail) Control

How to adjust the Sharpness
The Sharpness function is used to adjust the image sharpness of video signals when using a video decoder installed in the projector.
To adjust the Sharpness, press the (-) or (+) side of the 'SHARPN' button (image 6-5). The following barscale is overlayed on the
source image (image 6-6).
Press the (+) or (-) button until the sharpest display is attained. Detail level should be roughly proportional to the input signal quality.
Higher levels of detail improve good quality levels. Low levels of detail reduce noise in poor quality signals.
Image 6-5

6.4 Color (Saturation) Control

How to adjust the Color (saturation)
The Color function is used to adjust color saturation levels and is only active for Video and S-Video sources.
To adjust Color, press the (-) or (+) side of the 'COLOR' button (image 6-7). The following barscale is overlayed on the source image
(image 6-8).
Press the (+) or (-) button until the desired color saturation level is displayed. If the color is set to a 0% level, the result will be black
and white picture. If the color is set too high, the color levels in the image will be over-powering.
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
18
Image 6-4
Image 6-6
R5976691 CINE VERSUM 70/60 24112003