Alarm Clock - D-Link DPN-1021G User Manual

DPN-1021G GPON ONT VoIP Gateway with 1 GPON
Port, 1 10/100/1000Base-T Port, 1 10/100Base-TX Port,
and 1 FXS Port
User Manual

Alarm Clock

On the VoIP / Alarm clock page, you can configure the phone connected to the FXS port of the
gateway as an alarm clock.
Move the Enable switch to the right. Then specify the time at which the phone should ring in the
Hour and Minutes fields. In the Ring time field, specify the signal duration. Then click the
APPLY button.
When the gateway is powered off or rebooted, the system time is reset to the default
!
value. If you have set automatic synchronization for the system time, the internal clock of
the device will be configured after connecting to the Inter net. If you have set the system
time manually, you need to set the time and date again.
Figure 84. The VoIP / Alarm clock page.
Page 114 of 145
Configuring via Web-based Interface