Table of Contents
Advertisement
DPN-1021G GPON ONT VoIP Gateway with 1 GPON
Port, 1 10/100/1000Base-T Port, 1 10/100Base-TX Port,
and 1 FXS Port
User Manual
In the Static DHCP section, you can specify MAC address and IP address pairs (set a fixed IPv4
address in the local area network for a device with a certain MAC address). The gateway assigns IP
addresses in accordance with the specified pairs only when the DHCP server is enabled (in the
DHCP section, the Server value is selected from the Mode drop-down list).
To create a MAC-IP pair, click the ADD button. In the opened window, in the IP address field,
enter an IPv4 address which will be assigned to the device from the LAN, then in the MAC
address field, enter the MAC address of this device. In the Host field, specify a network name of
the device for easier identification (optional). Click the APPLY button.
Also you can create a MAC-IP pair for a device connected to the gateway's LAN at the moment. To
do this, click the CLIENTS LIST button. In the opened window, select the relevant device and
click the OK button. To view the latest list of the connected devices, click the REFRESH button.
To edit the settings for the existing MAC-IP pair, left-click the relevant line in the table. In the
opened window, change the needed parameters and click the APPLY button.
To remove a MAC-IP pair, select the checkbox located to the left of the relevant line in the table
and click the Delete button. Then click the APPLY button. Also you can remove a MAC-IP pair in
the editing window.
Figure 46. The section for creating MAC-IP pairs.
Page 62 of 145
Configuring via Web-based Interface
Advertisement
Table of Contents
