Introduction - Magtek ExpressCard 2000 Replacement Manual

2 - Introduction

2 Introduction
This procedure describes how to replace the XY transport ribbon cable in the ExpressCard 2000
(EC2000), and is based on content in 99875607 ExpressCard 2000 Hardware Service Manual. It
assumes the reader is familiar with basic operation of the ExpressCard 2000's user and maintenance
functions, so many of the cross-references to deeper "how-to" procedures from that manual have been
removed for brevity.
The information in this document is intended for use by trained professional service
personnel only. It is not intended for general use. To maintain the safety and integrity of
the device, it is important to follow the procedures laid out in this document as-written and
in the order provided.
CAUTION: For your personal safety, and to prevent damage to the device, disconnect
power from the ExpressCard 2000 before you connect or disconnect any cable, electronic
board, or assembly.
ExpressCard 2000| Instant Issuance Card Personalization System | XY Transport Ribbon Cable Replacement Procedure
Page 6