Line Hunt Groups - Talkswitch 48 User Manual

In the "Calibration" section:
After you have configured the lines, it is recommended that you calibrate the
lines. Completing this procedure optimizes your telephone line volume levels for
the Call Bridge and Call Forwarding (with Remote Extensions) features.
Note: Only lines that are detected can be calibrated.

2.3.1.2 Line Hunt Groups

There are a total of 9 Line Hunt Groups for controlling outbound call line selections.
These Line Hunt Groups are used by the Local and Remote Extensions, and when
using the Call Bridge feature. Each Hunt Group can support several line choices and
will attempt to grab an available line in the order that they are listed (Lines to hunt)
for that Hunt group. These settings have no effect on incoming calls.
The default setup:
Hunt Group 9:
Hunt Group 81:
Hunt Group 82:
Hunt Group 83:
Hunt Group 84:
28 TalkSwitch User Manual
selects any available line
selects Line 1
selects Line 2
selects Line 3 (for the TalkSwitch 48 only)
selects Line 4 (for the TalkSwitch 48 only)