AEMC 1510 Quick Start Manual page 3

Thank you for purchasing the Air Quality Logger Model 1510. For best results from
your instrument:

read these operating instructions carefully

comply with the precautions for use
WARNING, risk of DANGER! The operator must refer to these
instructions whenever this danger symbol appears.
Information or useful tip.
Battery.
Magnet.
The product has been declared recyclable after analysis of its life cycle
in accordance with the ISO14040 standard.
AEMC has adopted an Eco-Design approach in order to design this
appliance. Analysis of the complete lifecycle has enabled us to control
and optimize the effects of the product on the environment. In particular
this appliance exceeds regulation requirements with respect to recycling
and reuse.
Indicates conformity with European directives and with regulations
covering EMC.
Indicates that, in the European Union, the instrument must undergo
selective disposal in compliance with Directive WEEE 2002/96/EC. This
instrument must not be treated as household waste.
Precautions
This instrument is compliant with safety standard IEC 61010-2-030, for voltages up to 5V
with respect to ground. Failure to observe the following safety instructions may result in
electric shock, fire, explosion, and damage to the instrument and/or the installation in
which it is located.

The operator and/or the responsible authority must carefully read and clearly
understand all precautions to be taken prior to using the instrument. Thorough
knowledge and awareness of electrical hazards are essential when using this
instrument.

Observe the conditions of use, including temperature, relative humidity, altitude,
pollution degree, and location of use.

Do not use instrument if it appears damaged, incomplete, or improperly closed.

Before each use, check the condition of the housing and accessories. Any item on
which the insulation is deteriorated must be set aside for repair or disposal.

Never make measurements in atmospheres contaminated by solvents, which
could damage the sensor.

All troubleshooting and metrological checks must be done by accredited
personnel.
2