Table of Contents
Advertisement
8.
To specify a folder for Connection Manager, use the default folder or click Change to browse to the folder
you want to use.
9.
Click Install.
A separate wizard opens for installing Telit drivers. Some MultiTech devices use embedded modules from
Telit Wireless Solutions to provide cellular connectivity; these devices require Telit drivers.
10.
Select Complete setup type.
11.
When the drivers are installed, click Finish.
12.
In the Setup Wizard, click Finish.
Note:
If using a USB device, you can connect the device to the carrier's network with Connection Manager. Refer to
Connecting a
Device.
If using a serial device, you need to set up the device in Windows Device Manager before connecting the device.
Refer to
Setting Up a Serial Device in Windows Device
Setting Up a Serial Device in Windows Device Manager
To set up the device in Windows Device Manager:
1.
Make sure that your desired COM port for the serial device is available.
2.
Connect the serial device to the PC.
3.
Go to Control Panel > Device Manager. Make a note of the COM port number for the connected device
(in COM Ports).
Example: The COM port is COM31.
4.
Go to Action > Add legacy hardware.
®
MultiConnect
Cell MTC-LVW2 User Guide
To open Connection Manager after installation, check Start the MultiTech Connection
Manager when the installation is finished.
After the drivers are installed, you need to restart your computer if prompted by Windows.
Manager.
USING CONNECTION MANAGER
35
Advertisement
Table of Contents
