Table of Contents
Advertisement
Safety instructions for installation
Fit the wall units and cooker hood before fitting the SmartLine element to avoid
damaging it.
The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100 °C heat-resistant adhesive which will
not dissolve or distort. Any backmoulds must be of heat-resistant
material.
The SmartLine element must not be installed over a fridge, fridge-
freezer, freezer, dishwasher, washing machine, washer-dryer or
tumble dryer.
When installing the SmartLine element, make sure that the mains
connection cable cannot come into contact with hot appliance parts.
After installation, the mains connection cable of the SmartLine
element must not come into contact with any moving kitchen com-
ponent (e.g. a drawer) or be subject to mechanical loads which could
damage it.
Observe carefully the safety clearances listed on the following
pages.
40
Advertisement
Table of Contents
