Weslo Cadence G 3.9 User Manual page 7

1. To register your product and activate your
warranty in the UK, go to iconsupport.eu. If
you do not have internet access, call Customer
Service (see the front cover of this manual).
To register your product and activate your
warranty in Australia, email or post the
following information to the email address or
postal address on the front cover of this manual.
• your receipt (make sure to keep a copy)
• your name, address, and telephone number
• the model number, serial number, and name
of your product (see the front cover of this
manual)
2. Make sure that the power cord is unplugged.
With the help of a second person, carefully
raise the Right and Left Uprights (56, 57) to the
vertical position. Then, slide the Uprights down
onto the top of the Base (35). Make sure not to
pinch any wires.
3. Tighten two M8 x 20mm Screws (2) with two M8
Washers (5) and an M10 x 42mm Screw (1) into
the Base (35) and into the Right Upright (56) as
shown; do not fully tighten the Screws yet.
Repeat this step on the left side of the tread-
mill. Then, tighten all four Screws (1, 2, 6) on
each side.
1
2
3
7
57
56
56
5
6
35
35
2
1