Part Identification Chart; Assembly - Weslo Cadence G 3.9 User Manual

PART IDENTIFICATION CHART

Use the drawings below to identify small parts used for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity used for assembly. Note: If a part is not in the hardware kit, check to see whether
it is preattached. Extra parts may be included.
M8 Washer
(5)–6

ASSEMBLY

• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you fi nish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
M8 x 15mm
M8 x 20mm Screw
Screw (3)–2
M10 x 42mm Screw (1)–2
(2)–4
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• Assembly requires the following tools:
the included hex keys
a Phillips screwdriver
an adjustable wrench
To avoid damaging parts, do not use power tools.
6