Service And Maintenance - Festool Cleantec Series Original Operating Manual

Mobile dust extractors

Hide thumbs

Table of Contents

Available languages

Enlarged version

Observe the following when extracting dust generat-

ed by operating electric power tools:

If the exhaust air is discharged back into the room,

the air renewal rate L within the room must be suf-

ficient. The volume of air discharged back into the

room must not exceed 50% of the fresh air volume

flow (room volume V

x air renewal rate L

all the relevant regional regulations.

Remember: A moist main filter clogs more quickly

when extracting dry materials. Therefore, dry the

main filter before extracting dust or replace the

damp filter with a dry one.

8.3

Extracting fluids

Before extracting fluids, remove the filter bag (see

Chapter 7.8). We recommend using a special wet fil-

ter.

The dust extractor stops automatically when the

maximum level is reached.

CAUTION

Escaping foam and fluids



Switch off the machine immediately and empty

the dirt trap.

8.4

After finishing work



Switch off the mobile dust extractor and pull out

the mains plug.



Wind up the mains power cable.



Empty the dirt trap.



Only CTM 48 E LE EC: Close off the extractor

opening [1-2] using the sealing plug [1-1].

WARNING

Hazardous dust

Damage to the respiratory passage



Wipe down the mobile dust extractor and clean

all accessories thoroughly using the extractor

(inside and out) before removing from the work-

ing area.



Parts that you were not able to clean thoroughly

must be sealed in an airtight plastic bag prior to

transportation.



Wear a dust mask!

The machine shall be stored indoors only.



Place the mobile dust extractor in a dry room in-

accessible to unauthorised users.

). Observe

Risk of injury, electric shock



Always disconnect the mains plug from the

socket before performing maintenance work on

the machine!



All maintenance and repair work which requires

the motor housing to be opened must only be

carried out by an authorised service workshop.

Damaged safety devices and components must be

repaired or replaced in a recognised specialist work-

shop, unless otherwise indicated in the operating

manual.

EKAT

Observe the following instructions:

– A dust test must be performed at least once a year

by the manufacturer or an instructed person. This

test may include checks to determine whether the

filter is damaged, the machine is sealed properly

and the monitoring features are functioning cor-

rectly.

– During maintenance and repair work, all compo-

nents that cannot be cleaned satisfactorily must be

replaced. The old components must be sealed in

impermeable plastic bags prior to disposal in com-

pliance with applicable regulations for this type of

waste.

– Provided maintenance personnel or other persons

in the vicinity are not endangered, the user must

dismantle and clean the machine prior to perform-

ing maintenance work. Appropriate precautionary

measures include decontaminating the machine

prior to disassembly, making provisions for locally

filtered forced ventilation at the location of ma-

chine disassembly, cleaning the maintenance area

and appropriate personal protective equipment.

CTM 48 E LE EC, CTL 48 E LE EC