Technical Data; Intended Use - Festool Cleantec Series Original Operating Manual

CTM 48 E LE EC, CTL 48 E LE EC
GB
– Risk of explosion and fire hazard: do not extract sparks or hot dust, flammable or ex-
plosive dust (e.g. magnesium, aluminium, petrol, thinner, with the exception of wood),
aggressive fluids/solids (e.g. acid, leach, solvent).
– Observe all national safety regulations as well as the material manufacturer's speci-
fications!
– Do not damage the mains power cable (e.g. by driving over, dragging, etc.). Protect
from heat, oil and sharp edges. Do not pull the plug from the socket by the cable.
– Check the plug and the cable regularly and have them replaced by an authorised ser-
vice workshop should either become damaged. Always replace the mains power cable
with the type specified in the spare parts list.
– Do not expose the machine to rain.
– For reasons of safety, never operate the machine from an unearthed socket.
– Always use the machine socket for the purpose specified in the manual.
– Always use original Festool accessories.
– Pull the plug from the socket when the machine is not in use and prior to maintenance
and cleaning work.
– Do not lift or transport using a crane hook or lifting gear!
– Do not insert and remove the plug under load.
– In an emergency (e.g. short circuit or other electrical faults occur), switch off the ma-
chine and pull out the mains plug.
3

Technical data

Mobile dust extractors
Power consumption
Maximum appliance socket connected load
Max. suction capacity (air), turbine
Max. vacuum, turbine
Filter surface area
Suction hose
Length of the net cable
Sound pressure level as per EN 60704-2-1 / Uncertainty K
Protection category
Container capacity
Dimensions L x W x H
Weight
4

Intended use

CTM 48 E LE EC: The mobile dust extractor is de-
signed for extracting hazardous dusts with limit val-
ues up to 0.1 mg/m³ and wood dust from dust class
'M' in accordance with IEC 60335-2-69.
14
EU
CH
CTL 48 E LE EC: The mobile dust extractor is de-
signed for extracting hazardous dust with limit val-
ues up to 1 mg/m³ from class 'L' in accordance with
IEC 60335-2-69.
The mobile dust extractor is designed to extract wa-
ter
150 - 1100 W
2500 W
1200 W
204 m³/h (3400 l/min)
23000 Pa
6318 cm²
D 27 mm x 3,5 m-AS
7,5 m
72 dB(A) / 3 dB
IP54
48 l
630 x 406 x 640 mm
17,9 kg