Cleaning The Gryphon; Cleaning The Coin Path; Cleaning The Sorting Control; Cleaning Payout Senor System - CPI GRYPHON Operation And Service Manual

CLEANING THE GRYPHON

Before cleaning, take the proper steps to avoid causing damage during cleaning:
•
Turn off the power
•
Use a damp cloth only, there should be no way for fluid to enter the device
•
Do not use any solvents or scouring agents, these will damage the device

Cleaning the Coin Path

Passing coins can leave residues while travelling through the validator. These residues
should be cleaned from time to time for optimal operation, roughly once a year or when
indicated by the MMI.
Cleaning Aids
•
Compressed air
•
Small brush
•
Damp cloth
•
Lukewarm water
Steps
1. Turn power off.
2. Open acceptor assembly at the coin entry and hold it open.
3. Remove any debris from the validation and sorting area. Dust off any
accumulation with a small brush or compressed air.
4. Clean the coin path with a damp cloth.
5. Close the acceptor assembly.

Cleaning the Sorting Control

1. Follow the steps above, then unlatch the acceptor assembly and remove it from the
changer.
2. Detach rear coin validator cover.
3. Slightly pull apart the bottom frame of the validator on both sides, separating the
lower snap in hooks from the bottom to the top.
4. Check cover prism for dirt, clean prism from the inside using a soft, dry cloth or
cotton ball.
5. Check both sides of the sorting control for dirt.
6. Clean diodes using a soft, dry cloth or cotton ball.
7. Reinstall the validator cover.
8. Reinsert acceptor assembly in coin changer until it is seated properly.
9. Turn power on.

Cleaning Payout Senor System

If you continue to receive cleaning notifications, or the changer has difficulty paying out, the
payout sensor system is likely soiled and requires cleaning.
23
GRYPHON OPERATION AND SERVICE GUIDE