CPI GRYPHON Operation And Service Manual page 26

Problem Possible Causes
Checksum of Error in coin validator's memory
validator
defective
No response
from validator
module
Tube sensors
Defective
Checksum of
changer
Defective
No response
from cash- less
system
No response
Bill validator does not respond to
from bill validator
coin changer commands as:
No
Hopper does not respond to coin
communication
changer commands as
with hopper
No
Recycler does not respond to
communication
coin changer commands as
with recycler
Payout jam in
Payout disc could not be driven
tube
from initial position as:
26
GRYPHON OPERATION AND SERVICE GUIDE
•
Communication with coin
validator interrupted
•
Coin validator defective
•
Filling level sensors
soiled
•
Filling level sensors
defective
•
Error in coin changer's
data memory
•
Card system does not
respond to coin changer
commands as not
connected correctly or
defective no longer
available
•
Not connected correctly
or defective
•
No longer available
•
Not connected correctly
or defective
•
No longer available
•
Not connected correctly
or defective
•
No longer available
•
Coin jam in payout area
Remedy
Check and correct coin validator
configuration
•
Remove rear cover from coin
changer, unfold coin validator
and check whether ribbon cable
is still connected correctly with
interface module (bottom PCB)
and coin validator
•
Replace coin validator
•
Remove coin jam
•
Clean coin path
•
Display coin validator diagnostic
screen, if necessary, contact
service technician
Check and correct coin changer
configuration in the settings menu
•
Check card system
•
Deactivate communication with
card system
•
Check bill validator
•
Deactivate communication with
bill validator
•
Check hopper
•
Deactivate communication with
hopper
•
Check recycler
•
Deactivate communication with
recycler
•
Remove coin cassette and then
jammed coin. Reinsert cassette
and pay out coin from relevant