Acura 08P34-SEC-2001-81 Instructions For The Use And Care

Acura car cover instructions for the use and care

Instructions for the Use and Care of

Your Acura Car Cover

made of EVOLUTION Fabric

NOTICE: Do not dry this car cover in automatic dryers.

Your new cover will help minimize deterioration of the paint and upholstery of your

vehicle by shielding it from the ultra-violet rays of the sun, dirt, dust, tree leaves, sap,

bird droppings, industrial pollutants, and salt particles in the air. The cover, although

not waterproof, can keep your car dry in light precipitation, but not in a rainstorm. It

has been treated with a durable water repellent and is mildew resistant. The cover is

made from a "breathable" fabric and will not trap moisture, which can cause damage

to the paint.

INSTALLATION OF THE COVER

When installing your cover, make sure that the mirror pockets on the sides of the

cover are pulled over the mirrors before pulling the ends of the cover over the

bumpers (see figure A). The elastic ends of your cover will keep it secure under

normal conditions. On windy days, or for prolonged storage, it is advisable to use a

lock and cable fastened to the grommets at the sides of the cover. The lock and cable

are included in this kit.

FIGURE A

2D11011M

KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE

Table of Contents

Do you have a question about the 08P34-SEC-2001-81 and is the answer not in the manual?

Page 1 Instructions for the Use and Care of Your Acura Car Cover made of EVOLUTION Fabric NOTICE: Do not dry this car cover in automatic dryers. Your new cover will help minimize deterioration of the paint and upholstery of your vehicle by shielding it from the ultra-violet rays of the sun, dirt, dust, tree leaves, sap, bird droppings, industrial pollutants, and salt particles in the air.
Page 2 REMOVAL To remove the cover, first release both ends from under the bumpers. Fold the cover from one side of the car toward the middle. Remove the mirror pockets from the side mirrors carefully; do not pull or tug on them as this may tear the cover, or break the mirrors.
Page 3 USING THE CAR COVER CABLE AND LOCK Install the cable and lock as shown in the illustration. The locking system will be ineffective if the cable is incorrectly installed. The cable must be threaded through the loop on one end and locked to itself at the other end as shown (see figure D).

2d11011m