Tuning The Electronic Control Unit To The Radio Remote Control - Truma Mover SX Information

Information
Connecting diagram
Installation
in front of axle
Top view
B
A
Figure 1
Installation
behind axle
Top view
A B
Figure 2
Drive Drive
motor motor
– +
4 3 2
+ – +
A
- +
Drive Drive
motor motor
Battery
– +
4 3 2
– + –
B
-
+
Mover® SX
Tuning the electronic control unit to the radio
remote control
The remote control and the control unit are tuned to
each other in the factory.
If the control unit or the remote control is replaced, they must
be tuned to each other again in accordance with the instruc-
tions below.
1
Check that installation has been carried out in accordance
with the installation instructions, and make sure that the drive
rollers are not engaged. Check that the caravan battery is
–
properly connected and its condition.
B
Read the following instructions beforehand, as you only
have a limited time for tuning (approx. 10 seconds).
You will need a pen, a small screwdriver or similar to
press the reset button (k).
– Switch off the remote control with the slide switch (a).
– After switching on the control unit (e.g. battery cut-off
switch), wait (for about 15 seconds) until the red LED (j)
starts flashing slowly.
– Press the reset button (k) on the control unit (LED (j) flashes
more rapidly) until the red LED (j) flashes very rapidly.
– Turn the control knob (b) all the way to the left and hold it in
place – push the slide control (c) all the way forwards and
hold it in place, and at the same time switch on the remote
1
control using the slide switch (a). Release the control knob
(b) and slide control (c) within 10 seconds.
– When the devices have been successfully tuned, the
+
red LED (j) on the control unit flashes very rapidly and the
green LED 4 on the remote control remains permanently
A
on.
If tuning was unsuccessful, the red LED (j) flashes and
you have to repeat the process.
j
k
Figure 3
LED 4 a
b c