How To Connect The Mks-8075 - Sony CCP-9000-C Installation Manual

1-6. Installation of Options

1-6-2. How to Connect the MKS-8075

Structure of MKS-8075 (Extension adaptor)
Adaptor case :
Screw (BV3 x 10) :
Connecting plate A :
Connecting plate B :
Connecting plate C :
Panel cover (L) :
Panel cover (R) :
Cable (D-sub 50-pin):
m
. A maximum of three extension adaptors (maximum of
four when using the blank panel) can be connected either
horizontally, or vertically.
(Up to two extension adaptors can be connected horizon-
tally.)
(For an example of connection, refer to Fig. 1.)
. There are three methods of vertical connection as
described below. (Refer to Fig. 2. (on page 1-13.))
Method A : Install the extension adaptors on the panel so
that they have differences in height like a
flight of steps and with the same outside
appearance as that of the main panel.
Method B : Install the extension adaptors flat on the
panel with no difference in height.
(In such a case as installed on tabletop)
Method C : Install the extension adaptors in the rack.
(Horizontal connection is also required.)
. When extension adaptors are installed using both
horizontal and vertical connections, be sure to perform
the vertical connections first then perform the horizontal
connections.
. When the vertical connection (A) is selected, be sure to
secure all of the side panels with screws. Never panel it a
table top. (The fixing method is same as that of the main
panel.)
Fig. 1
Number of
2
connections
: Blank panel
1-10
1
4
1
1
2
1
1
1
3 4
(Using the blank panel)
Connecting procedure
1. Remove the module cover. Remove the screws (BV3
x 10) fixing the caps (L) and (R), and remove the caps
in the direction of the arrow.
2. Loosen the four screws (with drop-safe) fixing the
operation module.
3. Hold the two screws (with drop-safe) in the front of
the both sides of the operation module, and remove the
operation module.
Module covers
Cap (L)
BV3 x 10
Scrwes
(with drop-safe)
Operation module
4. Remove the screws (BV3 x 10) fixing the side plates
to the adaptor case, and remove the side plates.
BV3 x 10
Adaptor case
Scrwes
(with drop-safe)
BV3 x 10
Cap (R)
Side plates
BV3 x 10
CCP-9000