Table of Contents
Advertisement
When the Vertical connection is selected
(1) Connect the adaptor cases together.
(Be careful of the direction of the adaptor cases. See the
instruction given on the bottom of the adaptor case.)
(2) Fix the right sides and left sides of the adaptor cases as
shown in the illustration using the two pieces of the con-
necting plate C.
. When fixing the adaptor cases, you can select either the
flat connection or the connection like a flight of steps.
. When selecting the connection like steps of the
connection method (A), (see Fig. 2) the two screws
are secured with one notch offset each other.
. When the flat connection method (B, C) is selected,
(see Fig. 2) the two screws are secured in the same
height.
Adaptor cases
Connecting
plate C
BV 3 x 10
When the Horizontal connection is selected
(1) Connect the adaptor cases together.
(Be careful of the direction of the adaptor cases. See the
instruction given on the bottom of the adaptor case.)
(2) Fix the top plate of the adaptor cases at the locations
shown in the illustration using the two connecting
screws and the two connecting plates A for every two
adaptor cases.
BV3 x 10
Instruction given on the
bottom of the cases
CCP-9000
Instruction given on
the bottom of the case
Connecting
BV 3 x 10
plate C
BV3 x 10
Connecting plates A
Adaptor cases
(3) Fix the bottom plate of the adaptor cases at the loca-
tions shown in the illustration using the 4 connecting
screws (BV3 x 10) and 2 of the connecting plates B
for every 2 adaptor cases.
n
When the Vertical connection (A) is selected, there are
several locations where the connecting plate B cannot
be fixed.
BV3 x 10
Adaptor cases
5. Install the side panel.
n
The screw positions that fix the side panel are different
in the connection methods (A), (B) and (C) respective-
ly. (Refer to Fig. 2 (on page 1-13.))
6. Install the operation module and fix it by tightening
the four screws on the sides.
1-6. Installation of Options
BV3 x 10
Connecting plate B
1-11
Advertisement
Table of Contents
