Installation To Mks-8075 (Extension Adaptor) - Sony CCP-9000-C Installation Manual

1-6-1. Installation to MKS-8075 (Extension
Adaptor)
c
Be sure to disconnect the power cord before starting to
install modules.
If installation of modules is started with the POWER
switch left on, it may cause electrical shock damage
printed circuit boards.
Applicable modules
. MKS-8031TB Track Ball Module
. MKS-8032
DKS Fader Module
. MKS-8033
Utility/Shotbox Module
. MKS-8035
Key Control Module
Installation
1. Remove the module cover on both sides of the opera-
tion module that you want to remove, as shown.
2. Loosen the four screws (with drop-safe) fixing the
operation module.
3. Remove the operation module by holding the two
screws on the sides of the operation module.
4. Fit the operation module that you want to install into
the position as described in step 3. Fix the operation
module by tightening the four screws (with drop-safe)
on both sides.
CCP-9000
5. Install the module cover.
n
Installation of the MKS-8031TB requires installation
of the track ball after the module is installed in steps 1
to 5.
Install the track ball by following the procedure below.
Module covers
Screws
(with drop-safe)
MKS-8075
6. Rotate the ball cover counterclockwise to release the
lock.
7. Remove the ball cover and the track ball.
8. Rotate the ball cover clockwise until it is locked.
1-6. Installation of Options
Operation module
Screws
(with drop-safe)
Ball cover
Track ball
MKS-8031TB
1-9