Raymarine SportPilot Owner's Handbook Manual page 49

81057_6.book Page 45 Tuesday, February 21, 2006 2:21 PM
Chapter 4: Installing the SportPilot
5. Assemble the SportPilot to the steering shaft.
6. Retain the SportPilot using the split washer and retaining nut.
CAUTION:
Do NOT attempt to support the SportPilot during tightening.
Make sure the torque restraint bolt is removed so the SportPilot is
free to rotate as you tighten the retaining nut. This will prevent
damage to the SportPilot clutch.
7. Tighten the retaining nut to 25 lbft (34 Nm) maximum against the steering
end stop.
8. Assemble the steering boss to the SportPilot.
9. Secure the steering boss using the 4 screws and washers.
10. 1 inch (25 mm) steering shafts only:
11. assemble the adaptor collar to the steering boss
12. once assembled, fit the Raymarine woodruff key
13. Assemble the steering wheel to the SportPilot.
14. Secure the wheel using the nut and the washer. Make sure that the woo-
druff key is fitted before tightening the wheel.
Torque
restraint
Torque bracket Torque
screw bracket
45
D1369-2