Table of Contents
Advertisement
1-5-1. Installing the Plug-in Boards
c
Be sure to turn off the POWER switch before starting
installation work.
If installation work is started with the POWER switch left
on, it may cause electrical shock or damage to printed
circuit boards.
Each plug-in board of the Integrated Routing System IXS-
6700/IXS-6600 is allocated to a specific slot into which
they must be installed. Check to see that the respective
plug-in boards are installed in their respective slots.
The name of the board is shown near the eject lever at the
right-most end of each plug-in board.
Names of the printed circuit boards and the slot numbers,
to which the plug-in boards are allocated, are shown on the
Extract PWB stopper assembly inside the front panel of the
IXS-6700/IXS-6600. Install the respective plug-in boards
according to this instruction.
m
Check that connectors of the plug-in boards are securely
inserted into the mother board (IXS-6700 : MB-1085
board, IXS-6600 : MB-1086 board) without loose contact.
If any plug-in board is inserted into the incorrect slot, it
causes a system error and the system will not work correct-
ly.
IXS-6600/6700
Installation Procedure
1. Turn off the main power of this unit (IXS-6700 or
IXS-6600) and disconnect the AC power cord from the
outlet.
2. Loosen the four screws (with drop-safe) and remove
the front panel to the arrow.
Screw (with
drop-safe)
Front panel
(The illustration shows the IXS-6700.)
3. Remove the harness connecting between the front display
and the IF-20.
IXS-6700 IF-20 Slot 4
IXS-6600 IF-20 Slot 2
Harness
(The illustration shows the IXS-6700.)
Screws
(with drop-safe)
1-7
Hide quick links:
Advertisement
Table of Contents
