Rack Mounting; Precautions For Rack Mounting; Rack Mounting Procedure - Sony IXS-6700-C Installation Manual

1-6. Rack Mounting

The IXS-6700/IXS-6600 is mounted in the 19-inch standard
rack. To mount the IXS-6700/IXS-6600 in the rack, use the
specified rack mount kit and follow the procedure described
below.
Specified rack mount kit : RMM-10
n
If a rack mount kit other than the one specified is used, the
unit may not be able to be mounted in the 19-inch standard
rack.
Parts of the RMM-10N
. Rack tool
. Right rack mount adapter
. Left rack mount adapter
. Rack tool attaching screw
(B4 x 6 : 7-682-560-09)
. Adapter attaching screw
(B4 x 10 : 7-682-560-10)
Other required parts
To mount the unit in the rack, rack mount kit RMM-10 and
the following part are required.
. Screw for rack mounting
(B5 x 12 : 7-682-576-04)

1-6-1. Precautions for Rack Mounting

w
. To prevent the rack from falling or moving, fix the rack on
a flat and steady floor and the like using bolts or others.
If the rack falls due to the weight of the equipment, it may
cause death or serious injury.
. Be sure to use the specified rack mount kit.
If not, injury may result and the equipment may fall due
to insufficient strength.
. After rack mounting, be sure to tighten the screws on the
rack angle and fix the unit in the rack.
If the screws on the rack angle are not tightened, the unit
may slip from the rack and fall, causing injury.
c
When mounting the unit in the rack, note the following:
. Be sure to mount in the rack with two persons or more.
. Be careful not to catch your fingers or hands in the rack
mount rail or others.
. Mount in the rack in a steady posture.
n
If several units are mounted in a rack, it is recommended to
install a ventilation fan to prevent temperature rise inside
the rack.
IXS-6600/6700

1-6-2. Rack Mounting Procedure

This section describes the rack mounting procedure using
the RMM-10 rack mount kit.
1. Loosen the four screws (PS4 x 8) and remove the four
feet from the bottom of the equipment.
2 pcs
1 pc
1 pc
6 pcs
6 pcs
PS4 x 8
(The illustration shows the IXS-6700.)
4 pcs
2. Attach the rack tool to the side of the equipment using
the specified six screws.
n
Use B4 x 6 screws.
Tighten the screws to the following torque.
Tightening torque : 120 x 10
B4 x 6
(The illustration shows the IXS-6700.)
Feet
_2
N.m {12.2 kgf.cm}
Rack tool
Rack tool
Feet
PS4 x 8
B4 x 6
1-11