Inserting Batteries - LaserLiner DigiLevel Pro 120 Manual

Digital electronic spirit level with vertical and horizontal angle display and
point laser (650 nm).The slope can be indicated in degrees, IN/FT or percent
on the display.An acoustic signal indicates the horizontal or vertical position.
The slope memory enables angles to be projected elsewhere, while
the separate measurement memory allows up to 9 measurements results
to be stored and retrieved. Milled measuring surfaces, powerful fi xing
magnets, as well as additional vertical and horizontal vial, illuminated display.
Calibration function for increased accuracy and adaptation to measuring
surface.
7
1
2
3
15
11
13
17
16
12
14
08
GB
8 9 10
Keypad
1. (REF) – Angle reference value setting
2. ( ) – ON / OFF switch
3. ( ) ) – Acoustic signal on/off
) )
4. (MR) – Memory retrieval
5. (UNIT) – Unit of measurement selection
(° degrees / % / IN/FT)
6. (M) – MEMORY function
Display
7. Slope direction
8. Slope angle
9. Current memory position (M1 – M9)
10. Battery charge
DigiLevel Pro 30/60/120
11. Vertical vial
12. Horizontal vial
13. Magnets
14. Measuring surface, 30 / 60 / 120 cm
15. Point laser ON / OFF
16. Tripod threads, 1/4"
Rear
17 . Battery compartment

Inserting batteries:

Open the battery compartment (17) on the rear of the DigiLevel and
insert two new batteries (type AAA/LR03) in the manner indicated
by the installation symbols. Ensure correct polarity. The symbol (10)
indicates the level of battery charge.
Switching on and measuring:
The DigiLevel Pro can measure angles continuously to 360°.
• Switch the DigiLevel Pro on using the on/off switch (2).
• The current operating temperature in °C is shown for a few seconds.
• The slope angle is shown in the display (8). If slopes are measured
4
overhead, the direction of display adjusts automatically.
5
• The current slope direction is also shown by the symbol (7).
6
Selection of unit of measurement:
• Button (5) allows the desired unit of measurement to be selected
(° degrees, %, IN/FT)
Changing the angle reference value:
• With button (1), it is possible to transfer angles elsewhere. To do so,
set the device to the desired slope and press button (1). The display will
then change to "0.0", and the desired reference angle is now set.
The slope can now be transferred to other objects.
IMPORTANT: When all the slopes have been transferred, make sure
to deactivate the new angle reference value. To do this, switch off
the device by pressing the on/off switch (2) for at least 3 secs. Only
then will the value be reset itself to the measuring surface (14).
Acoustic signal:
• The acoustic signal can be switched on or off with button (3).
• When the angle of slope stands at 0°, 45°, 90° or the most recently
stored value, this is indicated by an acoustic signal.
NOTE: When working with a changed angle reference value, the
acoustic signal is activated on reaching the new reference value
(0°, 45°, 90° display).
DigiLevel Pro 30/60/120
09
GB