Advertisement
!
Read the operating instructions and the enclosed brochure „Guarantee and additional notices" completely.
Follow the instructions they contain. Safely keep these documents for future reference.
The automatic cross-line laser with plumb function and integrated hand-held receiver mode
for aligning tiles, wall studding, windows, doors etc.
General safety instructions
Caution: Do not look directly into the beam. Lasers must be kept
out of reach of children. Never intentionally aim the device at
people. This is a quality laser measuring device and is 100% factory
adjusted within the stated tolerance. For reasons of product liability,
we must also draw your attention to the following: Regularly check
the calibration before use, after transport and after extended periods of storage. We also wish to point out that
absolute calibration is only possible in a specialist workshop. Calibration by yourself is only approximate and the
accuracy of the calibration will depend on the care with which you proceed.
!
Always turn off all lasers and latch the pendulum in place before transporting, ON/OFF switch in its „OFF"
position!
1
Inserting batteries
Open the battery compartment
and insert batteries (4 x type AA)
according to the symbols. Be sure
to pay attention to polarity.
6
GB
2
Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out
levelling at great distances or when the laser
lines are no longer visible.
To work with a laser receiver, switch the line
laser into hand receiver mode with the Hand
receiver mode button. The laser lines will now
pulsate with high frequency, making the laser
lines darker. The laser receiver can detect
these pulsating laser lines.
!
Observe the laser receiver's operating instructions for line
–
+
+
–
lasers.
Laser radiation!
Do not stare into the
beam! Class 2 laser
< 1 mw · 635 nm
EN 60825-1:2007-10
Advertisement
