Table of Contents
Advertisement
im Vertrieb von
Installation and Operation, cont'd
LE
VE
L
PE
AK
BO
O ST
CE
NT
ER
IN G
CO
NT
RO
L
M IN
I VT
SX
G
G A
VG
XG
A
A
20
3
SV
G A
VT
V T
G
G
W IT
H AD
IN PU
Figure 2-3 — Under-desk mounting
2.
Hold the interface with attached brackets against the
underside of the desk or other furniture. Mark the
location of holes for screws on the desk.
3.
Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot
holes in the table or desk at the marked screw locations
from the underside/inside (concealed side) of the
furniture, where the interface will be located.
4.
Insert the four wood screws into the pilot holes. Fasten
each screw into the installation surface until just less than
1/4" of the screw protrudes.
5.
Align the installed screws with the slots in the mounting
brackets, and place the interface against the surface, with
the screws through the bracket slots.
6.
Slide the interface slightly forward or back, then tighten all
four screws to fasten it in place.
www.camboard.de
2-6
RGB 203 Rxi, RGB 203 Rxi VTG • Installation and Operation
SP
TM
T
1
2
3
CAMBOARD Electronics
Through-desk mounting
Tel. 07131 911201
RGB 203 Rxi, RGB 203 Rxi VTG • Installation and Operation
Fax 07131 911203
1.
If rubber feet were installed on the interface, remove them.
2.
Insert the machine screws provided in the optional
mounting kit (part #70-077-02) through the slots in the
through-desk mounting brackets, and loosely secure the
brackets to the interface (figure 2-4).
Figure 2-4 — Through-desk mounting
3.
Hold the interface with attached brackets against the
underside of the desk/table. With a soft pencil mark the
location of holes for screws on the desk. Mark the
opening, approximately 1.8" x 8.9" ( 4.6 cm x 22.6 cm).
4.
Cut out the material from the installation area with a
jigsaw. Check the opening size by inserting the interface
part way through the hole. If needed, use a saw, file or
sandpaper to enlarge the hole. Smooth the edges of the
hole with sandpaper.
ce-info@camboard.de
2-7
Advertisement
Table of Contents
