Deleting Data From The Bernina Usb Stick (Optional Accessory); Calibrating The Buttonhole Foot No. 3A; Updating The Software - Bernina 720 User Manual

Setup-Program
> Touch the icon «Setup Program».
> Touch the icon «Machine settings».
> Touch the icon «Basic settings».
> Touch the icon «Deleting data from USB Stick».
> Touch the icon «Confirm» to delete all data on the BERNINA USB Stick (optional accessory).

Calibrating the Buttonhole foot No. 3A

The Buttonhole foot No. 3A is calibrated to this machine and should only be used both together.
Prerequisite:
•
•
> Touch the icon «Setup Program».
> Touch the icon «Machine settings».
> Touch the icon «Maintenance/Update».
> Touch the icon «Buttonhole foot No. 3A».
> Touch the button «Start/Stop» to start the calibration.

Updating the software

NOTICE
BERNINA USB stick (optional accessory) has been removed too early
The software has not been updated and the machine cannot be used.
> Remove the BERNINA USB stick (optional accessory) only after the update has been completed
The latest software and a detailed step by step instruction can be downloaded at www.bernina.com. In
general, personal data and settings are automatically transferred during a software update. For reasons of
safety, it is recommended to save data and settings on a BERNINA USB stick (optional accessory) before the
software update is started. If personal data and settings should get lost during an update, they can be
transferred to the machine again afterwards.
60
The Buttonhole foot No. 3A is attached.
The needle is not threaded.
successfully.
036045.50.04_2014-10_Manual_B720_EN