Dc3 Desktop Charger And Dp1 Desktop Programmer - Avaya 3735 User Manual

DC3 Desktop Charger and DP1 Desktop Programmer

Figure 1: Chargers
You can use any of the following chargers:
• DC3 Desktop charger: Charges the handset only. The charger is delivered with a plug-in
power supply and connected to an ordinary wall socket.
• DP1 Desktop Programmer: Downloads new software and synchronizes parameters. The
handset becomes fully operational when you keep it in a charger.
Note:
Use the charger within the temperature range of +5° C – +40° C.
CR3 Charging Rack
The CR3 Charging Rack is used for:
• Charging several handsets
• Synchronizing parameters
• Downloading software
The built in power supply can charge up to six handsets.
Battery pack charger
The battery pack charger is used for charging up to six spare batteries.
373x Accessories
Belt Clips
The two belt clip options are:
• Hinge-type clip: The clip on the back of the handset is used to fasten the handset to a belt or
similar. The clip can also be changed to a swivel-type.
• Swivel-type clip: The ordinary belt clip can be replaced with a special swivel-type belt clip that
is adapted to firmly secure the handset into your belt.
August 2019 Using 3735 DECT handsets with Communication Manager and IP Office
Comments on this document? infodev@avaya.com
Accessories
19