Maxxus RunMAXX 5.0 Installation & Operating Manual page 15

Cockpit
- SPEED QUICK SELECTION KEYS
6 9
The treadmill cockpit has 2 quick selection keys for speed.
These quick selection keys are located to the left of the SPEED keys and make it possible to quickly select the
pre-set speed levels "6km/h" and "9km/h" directly
START/PAUSE Key
Start Function
This starts the Quick Start function or starts the training program selected.
Pause Function:
During training the treadmill belt can be stopped by pressing the START key once. The cockpit will switch into
pause mode for 5 minutes. If the START key is pressed within these five minutes, training will continue from
where it stopped. After the five-minute break, the cockpit will automatically reset, and all values will be set back
to zero. If the pause function is used, training can be continued by re-pressing the START key.
STOP Key
Stops the current training
Further Functions
Hand Pulse Sensors
Serve for short-term pulse measurement. Hold the hand sensors in both hands. After a short time, the current
pulse rate will be shown in the display. Please also read the section "Pulse Monitoring using Hand Sensors" and
"Warning about Pulse and Heart Rate Measurements" in this manual.
Heart Rate Receiver
The treadmill cockpit is fitted as standard with a receiver for wireless heart rate monitoring. This requires a
transmitter chest belt which is not included in delivery. The chest belt must transmit at 5KHz frequency and be
uncoded. Use of a Bluetooth chest belt is not possible. Please also read the section "Heart Rate Monitoring
using a Chest Belt" and "Warning about Pulse and Heart Rate Measurements" in this manual.
Hand Rail Control
The two hand rails on the treadmill are equipped with control keys. The left hand rail has a control key for IN-
CLINE and the right hand rail has one for SPEED. ENG
Switching on the Treadmill
Connect the mains plug on the power cable to a grounded, 16 A socket which has an individual fuse and been
installed by a professional electrician.
Now switch on the treadmill with the on / off button (located on the back of the motor housing)
Switching off the Treadmill
Press the On/Off key again to switch off the treadmill. Remove the mains plug from the electrical socket.
CAUTION:
Before you switch off the treadmill, always make sure that the incline level is at zero.
Quick start
Press the START button.
The treadmill starts automatically after a countdown and the exercise time will start to run.
Use the SPEED keys to adjust the speed, and the INCLINE keys to adjust the incline during your workout.
To stop training, press the STOP button
15