Delta SDR 510 U Manual page 51

Main Menu
● When selecting "USALS" Yellow Color
button
If you have a USALS motorized system,
you must set your position (latitude and
longitude) in order to calculate all motor
positions for viewable satellites. You should
refer to the motor's manual to get
information for installing a USALS
motorized system.
1) Longitude & Latitude: Input the value
of latitude and longitude in which the dish
installer is placed, press NUMERIC button.
2) Current Satellite: Indicate the current
satellite name.
3) Rotate: To move the motor to the stored
position, press OK button.
4) Limit: You can set the maximum move
extent. You can control Enable or Disable
mode. When you select Enable, East limit
and West Limit will be activated. Press the
OK key, then current position will be
restored as each limit.
5) Go to Reference: To clear the east &
west limit, press OK button.
Committed: Set the port number of
DiSEqC 1.0 switch.
Uncommitted: Set the port number of
DiSEqC 1.1 switch.
Save: After Setup complete, Press
RED Button to Save.
www.dct-delta.de 51 25.01.20074/19/2007