In the event of an overheating of the combustion chamber, the over- heating thermostat responds. It switches the device off and switches it back on after the device has cooled down (light (h) turns on and off again). A - 1 Operating manual – IDS 900...
In any case you have to: • Check that the power consumption of the fan motor does not exceed the specified value. • Check that the air flow rate corresponds to the nominal flow rate. A - 2 Operating manual – IDS 900...
Page 4
• Fasten the plate (1) to the air inlet of the burner. It must be rotat- ed so that the air hose (3) is blocked. The following image shows how to position the chimney: A - 3 Operating manual – IDS 900...
• Turn the switch (a) to "H" or "V+H": the burner starts the starting or pre-purging cycle. Then the flame is ignited. After the combustion chamber has been preheated for several minutes, the main fan switches on. A - 4 Operating manual – IDS 900...
Page 6
• Control of the trigger temperature of the burner thermostat chamber is not yet sufficiently heated. It also guarantees a discharge of the internal residual heat upon switch-off. The default temperature setting is 35 °C with a hysteresis of 5 °C. A - 5 Operating manual – IDS 900...
• Make sure that there are no sheets or blankets placed on the be done if it is absolutely necessary. For this purpose, device please contact the Trotec service to obtain the information required for reprogramming the temperature controller. • Make sure that the device is in a firm and stable position •...
• All parts must have dried completely before the power cable is reconnected If the inspections and corrective measures do not produce any re- sults, please contact your nearest sales and service centre. A - 7 Operating manual – IDS 900...
Page 9
• Remove foreign objects • Insufficient air circulation • Remove any obstacles affecting air circulation • Please contact the technical customer service • Insufficient heating • Insufficient heat output of the burner A - 8 Operating manual – IDS 900...
982 mm Height 1,584 mm Weight kg 351 kg Combustion indirect * ΔT indicates the temperature increase. The outlet air temperature is calculated from ΔT + ambient temperature. ** Optionally available accessories required. A - 12 Operating manual – IDS 900...