Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec IDX 30 D
Summary of Contents for Trotec IDX 30 D
- Page 1 IDX 30 D ORIGINAL INSTRUCTIONS OIL HEATER...
-
Page 2: Table Of Contents
Do not use the device in small rooms if persons are Information marked with this symbol helps you to carry present who cannot leave the room independently and out your tasks quickly and safely. who are not under constant supervision. oil heater IDX 30 D... - Page 3 Hold onto the mains plug while pulling the power cable data chapter. out of the mains socket. • Do not use the device in immediate proximity to curtains. • Make sure that the air inlet and outlet are not obstructed. oil heater IDX 30 D...
-
Page 4: Information About The Device
Improper installation entails a risk of fire. Do not place the device on combustible ground. Do not place the device on high-pile carpets. Warning The device must not be covered, there is an imminent fire hazard! oil heater IDX 30 D... -
Page 5: Transport And Storage
• dry and protected from frost and heat Tank filling level indication • in an upright position where it is protected from dust and Air outlet direct sunlight • with a cover to protect it from invasive dust if necessary oil heater IDX 30 D... -
Page 6: Assembly And Installation
5. Bolt the 4 large screws to the transport handle, device and Prior to initial start-up, the wheels and the axle must be frame. attached to the frame. To do so, please proceed as follows: 1. Slide the axle through the openings at the frame. oil heater IDX 30 D... - Page 7 If an accessory part is missing, please considered for the selection of the device's installation site. contact the Trotec customer service or the specialist dealer Non-observance may impair the proper functioning of the device where you purchased the device.
-
Page 8: Operation
3. Secure the device against inadvertent switch-on by pulling The operating light flashes: the mains plug. • The thermostat setting might be too low. Turn up the 4. Allow the device to cool down completely. thermostat setting. oil heater IDX 30 D... - Page 9 • Power failure: In the event of a power failure the ignition is extinguished, the device switches off immediately. After a power failure the device will not restart automatically, it has to be started via the on/off switch. oil heater IDX 30 D...
-
Page 10: Maintenance
ü Only use fuel suitable for the device (see technical data). 1. Position the device on firm, level and incombustible ground. 2. Unscrew the fuel tank cap (9). 1. Provide for a suitable collection container. 2. Move the device to an elevated position. oil heater IDX 30 D... - Page 11 This activity can be carried out along with the inspection of the air filters. Overview of air filters The filter housing consists of the following parts: • filter seal (30) • prefilter (31) • foam filter (32) • filter housing (33) 2. Remove the protective grid. oil heater IDX 30 D...
- Page 12 Ensure that no moisture enters the housing. Protect electrical components from moisture. Do not use any aggressive cleaning agents such as cleaning sprays, solvents, alcohol-based or abrasive cleaners to dampen the cloth. 4. Remove the upper part of the housing. oil heater IDX 30 D...
- Page 13 If the foam filter is heavily contaminated, clean it with warm water mixed with a neutral cleaning agent. 3. Allow the foam filter to dry completely. Do not put any wet filters into the device. oil heater IDX 30 D...
- Page 14 4. Insert both filters into the filter housing (33). Ensure the 2. Tighten the hexagonal bolts at the filter housing. proper seating of the seal (30). Assembling the filter housing 1. Attach the filter housing with filters and sealing. 3. Fasten the pressure gauge in place. oil heater IDX 30 D...
- Page 15 Assembling the upper part of the housing 1. Place the upper part of the housing on the device. 4. Tighten the 4 screws at the protective grid. 2. Tighten the 8 screws at the upper part of the housing. oil heater IDX 30 D...
-
Page 16: Technical Annex
388 x 942 x 460 (mm) (length x width x height) Minimum distance to walls or other objects Fuels The following fuels are approved for the device: • EL fuel oil • Kerosene • Diesel oil heater IDX 30 D... - Page 17 Wiring diagram oil heater IDX 30 D...
- Page 18 Spare parts drawing and list Info The position numbers of the spare parts differ from those describing the positions of other parts mentioned in this operating manual. oil heater IDX 30 D...
-
Page 19: Disposal
Fuel oil The fuel oil must be drained from the device and collected. Fuels are to be disposed of according to the national regulations. oil heater IDX 30 D... -
Page 20: Declaration Of Conformity
Declaration of conformity In accordance with the EC Machinery Directive 2006/42/EC, Annex II, part 1, Section A Herewith, we – Trotec GmbH & Co. KG – declare that the machinery designated below was developed, constructed and produced in compliance with the requirements of the EC Machinery Directive in the version 2006/42/EC. - Page 22 Trotec GmbH & Co. KG Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...