Trotec IDS 20D Original Instructions Manual

Trotec IDS 20D Original Instructions Manual

Oil heater

Advertisement

Quick Links

IDS 20 D / IDS 30 D
EN
ORIGINAL INSTRUCTIONS
OIL HEATER

Advertisement

Table of Contents
loading

Summary of Contents for Trotec IDS 20D

  • Page 1 IDS 20 D / IDS 30 D ORIGINAL INSTRUCTIONS OIL HEATER...
  • Page 2: Table Of Contents

    EU declaration of conformity via the following link: Assembly and installation............. 7 Operation ................ 10 Available accessories ............ 11 IDS 20 D Errors and faults.............. 11 Maintenance ................ 12 https://hub.trotec.com/?id=42204 Technical annex.............. 13 Disposal ................ 14 Declaration of conformity ........... 14 IDS 30 D Notes regarding the operating manual https://hub.trotec.com/?id=42205...
  • Page 3: Safety

    • This appliance is not a toy! Keep away from children and Safety animals. Do not leave the device unattended during operation. Read this manual carefully before starting or using the device. Always store the manual in the immediate vicinity •...
  • Page 4 Intended use Warning of flammable substances Handling fuels entails a risk of fire. The device was developed for the purpose of generating hot air Take sufficient precautions when handling fuels such and may only be used in roofed over outdoor areas or in well- as fuel oil, kerosene or diesel.
  • Page 5: Information About The Device

    Behaviour in the event of an emergency Information about the device 1. In an emergency, disconnect the device from the mains feed-in: Switch the device off and disconnect it from the Device description mains. The directly fired oil heater IDS 20 D serves the purpose of 2.
  • Page 6 Device depiction IDS 30 D IDS 20 D Designation Combustion chamber housing Handle Transport handle Air inlet with protective grid Fan and motor Control panel Tank Fuel tank cap Wheel Air outlet for hot air Fuel pump oil heater IDS 20 D / IDS 30 D...
  • Page 7: Transport And Storage

    Transport and storage Assembly and installation Note Scope of delivery If you store or transport the device improperly, the • 1 x Oil heater device may be damaged. • 1 x Transport handle Note the information regarding transport and storage of •...
  • Page 8 IDS 30 D Mounting the transport frame 1. Fit the two wheels on the axle. IDS 20 D 1. Connect the transport frame to the rear of the device. 2. Make sure that the holes for the screws are positioned flush above each other. 3.
  • Page 9 If an accessory part is missing, please considered for the selection of the device's installation site. contact the Trotec customer service or the specialist dealer Non-observance may impair the proper functioning of the device where you purchased the device.
  • Page 10: Operation

    Switching the device on Operation IDS 20 D The device may only be used by accordingly instructed persons. The IDS 20 D comes with a heating level without thermostat and Operating elements without integrated thermostat socket. Without a thermostat connected, the IDS 20 D can only be used in continuous IDS 20 D operation mode.
  • Page 11: Available Accessories

    Tasks which require the housing to be opened Note must only be carried out by authorised specialist Damage to the device due to overheating! companies or by Trotec. Never switch off the device by pulling the mains plug. Warning This may lead to overheating! Risk of injury due to improper repair! Switch off the device properly.
  • Page 12: Maintenance

    Tasks which require the housing to be opened has to be started via the on/off switch. must only be carried out by authorised specialist companies or by Trotec. There is a fuel leak: • Check whether too much fuel was filled in. Drain the fuel if Cleaning the housing necessary, see chapter Draining the tank.
  • Page 13: Technical Annex

    3. Fill the tank. 5. When no more fuel is discharged, seal the drain hole 4. Screw the fuel tank cap (7) back onto the tank. Observe again. ð Ensure the tight fit of the screw and, if required, replace the recesses at the tank opening and the protrusions at the fuel tank cap.
  • Page 14: Disposal

    The Annex II, part 1, Section A addresses can be obtained from your municipality or local Herewith, we – Trotec GmbH & Co. KG – declare that the administration. For further return options provided by us please machinery designated below was developed, constructed and refer to our website www.trotec24.com.
  • Page 15 Trotec GmbH & Co. KG Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...

This manual is also suitable for:

Ids 30d

Table of Contents