Advertisement
ADJUSTING CUTTING HEIGHT
The single height adjustment lever is located on the left side front wheel of the lawnmower.
Push the lever away towards the wheel and rotate up and down the cutting heights, locating the lever to
your desired height of cut.
The gauge has six cutting heights, numbered 1-6, with one being the highest cut (75mm) pushing the
lever to the front of the machine and six the lowest cut (25cm), moving the lever towards the rear of the
machine. Adjust the cutting height to suit your requirements.
COLLECTOR FULL INDICATOR
Your collector is fitted with a full indicator flap at the rear of the hard top. Whilst air is still rotating around
the collector and grass is being collected, the flap will raise and remain open. Once the collector is full, the
flap will remain closed, and you should empty the grassbox.
EMPTYING COLLECTOR
When the collector is ready for emptying.
Release the OPC lever and wait for the cutting blade to come to a complete stop.
Lift the rear flap.
Unhook the collector.
Remove any cuttings whilst wearing sturdy gloves, from the discharge chute of the mower.
Empty the collector contents into a suitable waste recycling bin or compost heap.
Lift the rear flap, refit the empty collector and sit the rear flap back onto the collector.
Advertisement
