Table of Contents
Advertisement
Connect AC Power
To connect the AC power cord to the switch, complete the following steps.
1. Connect the AC power cord to the AC power receptacle on the rear panel of the switch.
2. Connect the other end of the AC power cord to a properly grounded AC power outlet.
3. Confirm that the power is connected properly. The SYSTEM LED should be ON (see
Install SFP+ Modules
You can install or remove a mini-GBIC SFP+ module from a SFP+ port without having to power off the switch. To install an SFP+ module,
complete the following steps.
1. Insert the module into the appropriate SFP+ port.
2. Press firmly to ensure that the module seats properly into the connector.
g
NOTE
The SFP+ ports are intended for use with Class 1, UL-listed optical transceiver products, rated 3.3 VDC.
Initially Configuring the Switch
The Switch can be configured by two methods:
■
Web based Graphical User Interface (GUI)
■
Command Line Interface (CLI)
4
Figure 7. Connecting the AC Power Cord
Figure 8. Installing an SFP+ Module into an SFP+ Port
"SYSTEM Status
LED").
617108124PF2-13C
Advertisement
Table of Contents
