Heat & Glo LOGS-Cerona42 Log Placement Instructions

Log Set Assembly:

Model:
Cerona-42
If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately,
refer to the following instructions.
CAUTION: Carefully remove the logs
from the packaging. Logs are fragile!
STEP 1.
LOG #1 (SRV2107-701):
Place log #1 over the back side of the burner
plate and slide forward until log hits the grate.
Log cut out should fit over pilot bracket. See
Figure 2.
STEP 2.
LOG #2 (SRV2107-702):
Fit log #2 on the right side of the grate. The
log is formed so it will sit around the right grate
bar. Rest the top of the log on the flat section
of log #1. See Figure 3.
LOGS-Cerona42
5
2
4
Figure 1
Figure 2
Figure 3
Heat & Glo • Cerona-42 • 2107-935 Rev.B • 7/06
1
6
3
1
FORM FITTED
TO GRATE TINE
LOG PLACEMENT
INSTRUCTIONS
2
1