Heat & Glo LOGS-6000G Log Placement Instructions

Log Set Assembly: LOGS-6000G
Models: 6000G, 6000GBV, 6000GCF
If the gas logs have been factory installed they
should not need to be positioned. If the logs have
been packaged separately, refer to the following
instructions.
STEP 1.
CAUTION: Logs are fragile! Carefully remove
the logs, grate and supporting cardboard from
the inside of the fi replace See Figure 1.
STEP 2.
Place the metal grate on top of the burner.
Position the legs of the grate into the forward set
of indentations in the burner top. Make sure that
grate is all the way forward. See Figure 2.
STEP 3.
Log #1 (SRV2103-107):
Place the log on the burner so the cutout in the
log goes around the hump in the burner. The outer
legs of the log should self center on the sides of
the burner. Pull the log forward. The ramp shape
in the bottom of the log sits fully against the ramp
shape molded into the burner. The right side of
the log will touch the smaller hump. There will
be a 1/4 inch or so gap around the hump. See
Figures 3 and 4.
Figure 3 Front View
1 1
Heat & Glo • 6000G • 2103-910 Rev. C • 8/06
3 3
2 2
Figure 1
Figure 2
Figure 4 Top View
LOG PLACEMENT
INSTRUCTIONS
1 1
4 4
5 5
HUMP
SMALLER
HUMP
INDENTATIONS
1 1