Table of Contents
Advertisement
9.6
Removing the Processor
Required Tools and Supplies
•
Anti-static wrist strap and conductive foam pad (recommended)
4. Unlatch the processor load plate (see Section 9.2 step 2).
5. Lift open the load plate (see Section 9.2 step 3).
6. Remove the processor by carefully lifting it out of the socket, taking care not to drop the processor as well
as not touching any pins inside the socket.
7. If a replacement processor is not being installed, install the socket protection cap.
9.7
Memory (DIMM) Installation
1. Locate the DIMM slot for installation. Ensure that the DIMM ejection tabs at both ends of the DIMM slot
are pushed outward to the open position (see Letter A).
2. Carefully unpack the DIMM, taking care to only handle the device by its outer edges.
3. Align the notch at the bottom edge of the DIMM with the key in the DIMM slot (see Letter B).
4. Insert the DIMM into the slot (see Letter C) pushing down on the DIMM, until the ejection tabs snap into
place (see Letter D). Ensure that the ejection tabs are firmly in place (see Letter E).
9.8
Memory (DIMM) Removal
1. Identify and locate the faulty DIMM. Ensure that the ejection tabs of adjacent DIMM slots are closed.
2. Open the DIMM ejection tabs at both ends of the selected DIMM slot (see Letter A). The DIMM will slightly
lift up from the slot.
3. Holding the DIMM by its edges, lift it away from the slot (see Letter B).
Intel® Server Board M10JNP2SB User Guide
Figure 29. DIMM installation
Figure 30. DIMM removal
43
Advertisement
Table of Contents
