Heat & Glo LOGS-750TRS-E Log Placement Instructions page 2

NOTCH NOTCH
STEP 4.
LOG #3 (SRV2120-703) Place log #3 on right fl at side of
burner assembly. The notch on the log should fi t over the
bar on the far right side of the grate. Push the log back
against the grate tab.
STEP 5.
LOG #4 (SRV2120-704) Place log #4 so that the right
end sits in the notch or fl at spot of log #2. The left end of
the log will sit on the left grate tine and also contact the
vertical portion of the grate tine as shown in Figure 4. The
"burned" part of the log should be pointed downward.
STEP 6.
LOG #5 (SRV2117-705) Place log #5 on log #2. Log #5
will mate with the fl at areas located on the top side of Log
#4. See Figure 5.
Figure 3.
Figure 4.
Figure 5.
Heat & Glo • LOGS-750TRS-E • 2120-945 • 3/11
2 2
1 1
"BURNED" PORTION
POINTS DOWNWARD
4 4
1 1
NOTCH
MATE WITH FLAT AREAS HERE
5 5
4 4
1 1
3 3
NOTCH
2 2
3 3
2 2
3 3