Installing The Keyboard In The Console Unit - IBM 7316-TF4 Manual

Installing the keyboard in the console unit

Learn how to install the keyboard in the console unit.
To install the keyboard in the console unit, complete the following steps:
1. Place the console unit on a table or other flat surface and make sure that the right side of the unit
extends approximately 76 mm (3 in.) over the edge of the surface. This will help you route the
keyboard-and-mouse cable more easily later in the procedure.
2. Carefully lift the front of the flat-panel display to the full upright position.
Attention: Do not extend the keyboard feet. The flat-panel display screen might be damaged if the
feet are extended when the display is closed.
3. Hold the keyboard near the keyboard tray and carefully route the keyboard-and-mouse cable down
through the keyboard tray cutout and up through the cutout that is behind the flat-panel display. (See
the illustration.) Carefully pull the cable through the cutouts.
4. Peel the backing of the double-sided foam tape that is preinstalled on the front of the console tray.
8
Power Systems: 7316-TF4 18.5-Inch Flat Panel Rack-Mounted Monitor and Keyboard