IPC1801-Z36&2802-Z18&5802-Z20
User Guide
6.5 Setting PPPoE Parameters
Preparation
Obtain the PPPoE user name and password from the network carrier.
Description
If a PPPoE connection is used, you need to enter the user name and password on the PPPoE
page. After you restart the device, the PPPoE settings take effect and the device obtains a
public IP address.
Procedure
Step 1 Choose Network Service > PPPoE.
The PPPoE page is displayed, as shown in Figure 6-7.
Figure 6-7 PPPoE page
Step 2 Select Enable PPPoE.
Step 3 Set the parameters according to Table 6-6.
Table 6-6 PPPoE parameters
Parameter
Enable PPPoE
User Name
Password
Step 4 Click OK.
Issue 12 (2014-06-12)
Description
Indicates whether to enable the
PPPoE service.
PPPoE user name provided by the
network carrier.
Password provided by the network
carrier.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Network Configuration
Setting
[Setting method]
Select the check box.
[Setting method]
Enter a value manually.
[Setting method]
Enter a value manually.
48