Hardware Configuration; 20.11.1 Addresses; 20.11.2 Inputs; 20.11.3 Redundancy - Siemens ET 200M Manual

8-Channel HART Analog Input MTA
20.11

Hardware Configuration

Use the 2 – 4 jumpers to select either 2 or 4 wire transducer.
See Figure 20–1 Item 5, for the location of the shield isolation jumpers and Item 9,
for the location of the 2 – 4 jumpers.

20.11.1 Addresses

Non-redundant Operation
The choice of the Input Address and Process Image are left to the user.
Redundant Operation
Process Image should be set to something other than the default. The choice of the
Input Address is left to the user.

20.11.2 Inputs

The inputs must be configured as 4 wire transducers.

20.11.3 Redundancy

For non-redundant operation the value of the Redundancy field should be None.
20.12 Technical Specifications for 8-Channel HART Analog
Input Module (6ES7 331-7TF01-0AB0)
Note
For a complete functional description and the most current technical specifications
for this module, refer to the manual ET 200M distributed I/O device HART analog
modules (document number A5E00434623).
262
Marshalled Termination Assemblies for ET200M Remote I/O Modules
A5E00482820-12