DAL-BO Rollomaximum XL Manual page 35

1 Drain oil from cylinder by moving ram carefully backwards and forwards.
2 Extend cylinder halfway. Unscrew and remove upper part (3) from cyl-
3 Remove the ram shaft (2) which retains the collar shoe (4).
4 Remove collar shoe (4) from ram shaft (5).
5 Remove upper part (3) from ram shaft (5).
6 Remove gaskets.
7 Clean all parts and check for particles etc. Check for rust around scraper
Assembly
1 Fit new gaskets in upper part and collar shoe.
2 Apply oil or grease to thread in upper part (3) and cylinder tube (1).
3 Fit upper part (3) on ram shaft.
4
5 Lubricate outer collar shoe gasket in contact with cylinder tube and inside
6 Fit upper part onto cylinder tube and tighten.
7 For fitting cylinder see "Fejl! Henvisningskilde ikke fundet.".
Rollomaximum XL
Replacing the gasket set in the crackerboard cylinder
3
Cylinder 25/60/25-205
inder tube (1). Use special tool to remove upper part. If upper part is
stuck, heat front of upper part. When upper part is detached from cyl-
inder tube, pull ram up towards upper part and remove completely from
cylinder tube (1).
ring on upper part. If detected, remove thoroughly.
Mount collar shoe (4 ) and the ram shaft (2) is secured with Loctite. Ensure
that thread is absolutely clean and free of oil or other impurities before apply-
ing Loctite. Do not fill with oil for 12 hours after use of Loctite.
of cylinder tube with oil, push ram into centre position.
4
5
1
2
Page 35