Table of Contents
Advertisement
Page 16
Rollomaximum XL
Retraction
The wheel frame (marked:
yellow) is activated and the
machine is lifted off the
ground.
The tilt cylinder (marked:
white valve block no. 4) is
retracted and the machine is
tilted forward to the side
frames and the centre frame
is in the upright position.
The extend/retract cylinder
(marked: red) is activated
again and the side sections
are retracted in over the
transport cradles (A).
The tilt cylinder (marked:
white valve block no. 4) is
activated and the side arms
are lowered into the transport
cradles (A). Finally the tilt
cylinders are depressurised
by briefly setting the outlet
(marked: white valve block
no. 4) to the float position.
A
A
Advertisement
Table of Contents
