Network; Ethernet Settings - Grandstream Networks GXV3380 Administration Manual

- Show received files: Shows the Transfer history of Bluetooth files
- Additional Settings: This menu is available only when the Bluetooth is enabled:
 Device Name. Tap to change the name of the GXV3380, which is displayed on other
Bluetooth devices when discovered. By default, it's "GXV3380_XXXXXX" where "XXXXXX"
are the last 6 digits of the phone's MAC address plus 2, for e.g. If the phone's last 6 digits of
MAC address is D33B4C, the Bluetooth's name would be GXV3380_D33B4E.
 Visibility timeout. Tap to select the timeout interval among "2 minutes", "5 minutes", "1 hour"
or "never". By default, the visibility timeout is 2 minutes.
 Visibility to nearby Bluetooth devices. Sets the visibility of the phone to other Bluetooth
devices. Normally this option is enabled during pairing process so that other Bluetooth devices
can discover the GXV3380.
-
Available devices: This section will show the available devices for pairing. Tap on
scan process on the GXV3380 to discover the Bluetooth devices within the range.

Network

Users can configure Ethernet settings, Wi-Fi, VPN, PPPoE and other advanced network settings here.

Ethernet Settings


Preferred Internet Protocol: Selects which Internet protocol to use. When both IPv4 and IPv6 are
enabled, phone attempts to use preferred protocol first and switches to the other choice if it fails.

IPv4 Settings: Here user can configure the IPv4 address Type. If DHCP is selected, the phone will
get an IP address automatically from the DHCP server in the network. This is the default mode. If Static
IP is selected, manually enter the information for IP Address, Subnet Mask, Default Gateway, DNS
Server and Alternative DNS server. If PPPoE is selected, type PPPoE Account ID and PPPoE
Password provided from the PPPoE server to get authenticated for network access.

IPv6 Settings: Here user can configure the IPv6 address Type. If Auto-configured is selected, the
phone will get an IP address automatically from the DHCP server in the network. This is the default
mode. If Static IP is selected, manually enter the information for IP Address, Prefix Length, DNS Server
and Alternative DNS server.

802.1x mode: This option allows the user to enable/disable 802.1x mode on the phone. The default
setting is disabled. To enable 802.1x mode, select the 802.1x mode and enter the required configuration
depending on the 802.1x mode chosen. The available modes are EAP-MD5, EAP-TLS and EAP-PEAP
GXV3380 Administration Guide
Version 1.0.1.19
to initiate
P a g e | 26