Alarming / Disarming The Vss During The Alarm / Prealarm; Emergency Disarming Of The Security System; Passive Arming (*) / Automatic Central Door Locking (*) - Mongoose MAP77 User Manual

Canbus vehicle security system
Hide thumbs Also See for MAP77:
Table of Contents

Advertisement

ALARMING / DISARMING THE VSS DURING THE ALARM / PREALARM

If the VSS is armed and any door, trunk or bonnet switch, additional sensor,
ultrasonic motion detector or ignition is triggered, the VSS starts a 30-second alarming
cycle - blinking the direction indicator lights and emitting sounds with electronic siren.
From triggering of the alarm till disarming the system with remote the LED blinks quickly,
2 times faster than in untriggered armed mode. After 30 seconds, the system stops the
alarm cycle. Further triggering of sensors starts another alarm cycle. Every input can
cause up to 4 alarm cycles and then it is blocked.
During alarm cycle, pressing LOCK button ends the alarm, but the vehicle
remains locked and the VSS remains armed. During alarm cycle, pressing
UNLOCK button stops the alarm, disarms the VSS and opens the vehicle. If the
PREALARM function is present, the device signals prealarm triggering by 4 siren
hirps.

EMERGENCY DISARMING OF THE SECURITY SYSTEM

MAP77 CAN has a procedure of emergency disarming the security system in
case the remote control is inoperative or not available (not working or lost).
In order to disarm the system with PIN code:
1.
Open the door with the key (the alarm will sound).
2.
Turn the ignition on.
3.
Press the PA button number of times equal to the first digit of your PIN
code (intervals between pressing of PA button have to be less than 2 seconds).
4.
Wait 2 seconds - the VSS confirms entering of PIN code digit via 1
second LED blink.
5.
Repeat steps 3-4 for each of the remaining 3 digits of your PIN code.
If the PIN code is correct the alarm will disarm itself
The default PIN is 1111. The code can be individually programmed for a given
car by installer during installation procedure.

PASSIVE ARMING (*) / AUTOMATIC CENTRAL DOOR LOCKING (*)

On a demand, the passive arming (*) with or without automatic central door
locking (*)can be enabled. Passive arming function arms (switches on) the VSS
automatically.
With the ignition off, opening and closing driver's door starts the timer of
passive arming procedure. it is signalled by a single siren chirp. 12sec. later, the
alarm arms automatically, signalling it with LED, siren chirp (*) and hazard lights.
The central door locks remain unlocked driver can still get into the vehicle.
Passive arming can be stopped if the UNLOCK button is pressed in the 12sec.
period after closing driver's door. Cancel of passive arming is signalled by
double siren chirp - passive arming will not occur.
If the automatic central door locking (*) is enabled, the door locking occurs
8sec. after passive arming of the VSS and is signalled by single siren chirp.
During that 8 seconds period between passive arming and automatic
locking, press of the LOCK button locks the vehicle (confirmed by single siren
chirp); press of the UNLOCK button disarms the VSS, unlocks the vehicle and
cancel the passive arming.
The sequence of events (first passive arming with chirp, then automatic
central door locking) prevents from locking the keys inside vehicle.
c

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MAP77 and is the answer not in the manual?

Questions and answers

Table of Contents