Table of Contents
Advertisement
3.1 Tools required
The following tools are required to install any of the transducers listed under "Applicable products".
1
Power drill
2
62 mm (2
Adhesive tape
3
4
Water based anti-fouling paint.
5
9 mm (⅜ inch) drill bit (for drilling anti-rotation bolt hole)
6
13 mm (½ inch) wrench (spanner) or suitable size adjustable wrench (spanner)
7
Drill bit (suitable size for drilling pilot holes)
8
Half round file
9
Marine grade sealant (non-acetate based)
10
Paint brush (for application of anti-fouling paint)
11
Non-corrosive locking wire
Warning: Marine-grade sealant
Only use marine-grade neutral cure polyurethane sealants. Do NOT use sealants
containing acetate or silicone, which can cause damage to plastic parts.
20
/
inch) hole cutter
29
64
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
