Bomag BVP 10/30 Operating Instruction page 68

Fig. 60
Fig. 61
Fig. 62
Fig. 63
Operation – Starting the engine
8. Stand behind the machine on one side and hold the
machine's guide handle with one hand.
9. Using the other hand, pull the rope by the starter handle, until
resistance can be felt.
10. Guide the starter handle back to initial position.
11.
NOTICE!
The starter rope may tear off!
– Do not pull the starter rope all the way
against the end stop.
Pull the starter handle quickly and with power.
ð The engine starts.
12. Manually guide the starter handle back to initial position.
13. If the engine does not start during the first attempt, repeat the
starting process.
14. When the engine is running, open the lever of the choke bit
by bit.
NOTICE!
Danger of engine damage!
– Warm up engine for a short while before
starting work. Do not operate the engine imme-
diately under full load.
15. Run the engine warm for approx. 1 to 2 minutes in idle
speed.
ð At idle speed vibration is switched off.
BVP 10/30 69