Avaya Scopia XT Series Quick Setup Manual page 3

Step 4. Remove the Back Panel
x1
The above symbol is meant
to represent snapping the
component into place.
IMPORTANT NOTE:
Remember to support the
back panel when unlocking
to prevent it falling.
Step 5. Install the Codec Mount
1. Place the XT5000 Codec Unit with the
connectors facing to the right.
Connect all the required cables (see
2.
the Installation Guide for Avaya Scopia
XT5000 for details).
3. Connect the microphone pod cable and
place it on the table, located 2m away from
the display screen (see the Installation
Guide for Avaya Scopia XT5000 for
details).
x1 x4 x4
Step 6. Assemble the Camera Mount Arm
IMPORTANT NOTE:
Ensure the arm faces the
opposite direction to the
mounting extrusion brackets.
4 | avaya.com
Insert XT5000 Fit Codec Mount
i i i
Codec Unit into bracket on to inner column
Connections
should be visible
Insert 4 bolts and loosely Slide assembled Camera
i i i
fix with 4 square nuts Mount Arm
Locate square nuts
into the channels
Tighten
i i i
4 bolts
Extrusion
Brackets
Avaya Scopia XT Meeting Center | Quick Setup Guide
Step 7. Install the Camera Mount Platform and Mount Camera
i
IMPORTANT NOTE:
Tighten M5 bolts once camera
Has been mounted as required.
Step 8. Install Completed Camera Mount Assembly by Placing on the Screen Mount
Avaya Scopia XT Meeting Center | Quick Setup Guide
Install Camera
Mount Platform
Mount Camera
i i
to Platform
Loosen all 8 bolts from Tighten all 8 bolts to
step 3 to adjust vertical secure camera assembly
position in vertical position
Slide camera mount Tighten both grub
assembly to desired screws to secure
horizontal position
avaya.com | 5